I decided to try my hand at tracing a couple of car logos and printing them from PLA. My first attempts were the Caterham written logo that uses their custom font, and the Lotus logo using the font style and layout from the logo used until the early '70s. For scale, each letter in the Caterham logo is 4" tall (100mm) and spelled out is a bit under 50". The Lotus logo is a little smaller, with the diameter of the C in the ACBC portion coming in at 6.5" and the letters a little over 3" tall (80mm). Each piece is attached to the wall with a non-hardening adhesive putty which makes it easy to make slight adjustments. Photos below include close ups of the finish. Next up, are attempts at the Porsche written logo and the Westfield starburst logo